|
Our new stretch blow 3/4 automatic Machine operates with one single cavity mould with the extensice range of bottle blowing from 100 - 5000mL. It opens for the investor the possibility to build a large spread of PET-Bottles/Container Products.
Please note, that the cycle- and heatingtimes are steady to obtain and keep the best production profile
The manual Feed-In permits at economic investmentcosts a large variation of diameters of the openings and shapes by unskilled operators.
Extension possible up to 10000ml
Design Features
-
Higher Output (70% higher in average)
600BPH vs 200~250BPH for 5.0L bottle;
900BPH vs 400~600BPH for 0.5L bottle.
-
Much More Safety, and Easier Operation
No need to insert heated preforms (hot & difficult!) into blow mold by hand (dangerous!) or take molded bottles out of blow mold (dangerous!).
-
Less Dependence on Operator, Steady Production
What the operator needs to do is feed cold preforms only (before heating). Once time setting is fixed, machine will continue production independently at fixed output.
-
Wider Application
Neck Range: dia.20~120mm, Volume Range: 100ml~5000ml
With one machine, you can produce almost all kinds of common PET bottles.
-
Less Mold Cost
As VS600 works single cavity blow mold. The mold cost is relatively lower than previous 2 cavity blow mold.
Related Media:
|
For further information:
Please contact us.
|
